Search for:
Advanced Search
[Login | Register]
Shopping Basket
Your basket is empty.
0Items in cart:
$ 0.00Total:
 
Information
Products: 299
Categories: 24
Prices: Australian Dollars
 
Mailing List
Subscribe to our mailing list below:
Email:
 
Language
 
Location: Shortcut to Homepage /Electronics/Opto Gas Engine Kill Switch

Opto Gas Engine Kill Switch

Opto Gas Engine Kill Switch

Product Information


42% Products OPTO-Remote Electronics Ignition Kill switch

One of our most popular items, 1000's sold.

  • OPTO Coupled input/output
  • 8 Bit Pic Controller
  • Li-Po/Li-Ion/Ni-Mh/NiCad input
  • Upto 10 Volt 15 amp Mos-Fet output
  • DSP Noise / Loss of signal Filtering - Further improved in stock sold July 08 onwards.
  • PPM-PCM 2048 – 1024  & 2.4Ghz Interface Support
  • Low Voltage Drop – Less than 150mv
  • 100% Surface Mount Technology
  • Heavy Gauge Wires, universal connectors.
  • Small and light weight – only 12 Grams!
  • Works with nearly any brand of electronic ignition - DA / DL / 3W / RCXCEL / MELODY / XYZ etc
  • Best value & Quality Ignition Kill Switch on the market.
  • Lifetime Warranty - Made in USA

 

One lead Plugs in to spare switch channel on receiver (ie gear channel is commonly used) other leads plug inline between your ignition power switch and the ignition/CDI


Opto Isolation separates ignition power system from radio system.


Allows you to kill the engine remotely by disconnecting power to the ignition.

 

Bright red remote mounting LED to let you know the ignition has power and is armed.

 

This is a must have safety device for gas powered planes.


Will also kill the ignition if you lose power to your receiver (dead battery etc)


Reliable & saves weight, as you don’t need to use another servo and mechanical micro switch.

 

Manual - optogaskill.pdf

 

 

Some Common FAQ's

Qn. How to they handle PCM Failsafe, will they keep the ignition going, or react to the failsafe setup for the particular channel of the rx?
If programmed in PCM to keep a signal going to the unit then yes it stays ON Otherwise a Loss of signal engine turns off. 

Qn. If the RX loses power, Im assuming the ignition is killed?
Yes.

Qn. Does the switch monitor for valid RX signal etc?
Yes 30 Valid pulses are required to sustain operation 

Qn. Can the switch handle multi cylinder ignitions with higher current draw (ie DA100/150's , multi cyl 3W's ) 
Yes up the 3W 420 has been used ( Can handle up to 10 amps of Ign power)

 Manufactured by 42Percents Products, USA .

 

 

(Based on 3 Reviews)

Price: $ 48.00


Product Code: OPTOIGNKILL
In Stock
Quantity: Add to Basket
Featured Product
 
Popular Products
 
Sale Items